Monday, October 26, 2015

Change Your Flat Tire Safely

This is a quick run-down on what to know and steps to take when changing a flat tire. We’re sure there are more tips than this, but these are good universal tips for all of us.

1. Pull your vehicle as far over or even off the main road if possible for safety.

2 .Locate the jack and tire wrench in your vehicle. If you are unsure where it is, pull out the manual and look it up. Many times it is located in the trunk somewhere.

3. Follow the instructions in your manual or on the jack to place the jack in the correct spot underneath and get it snug on the frame while not quite raising it up yet.

4. Take your wrench and start to loosen each lug nut just a little so each is started.

5. Once they are loose, go ahead and jack the vehicle up until the vehicle tire is off the ground.

6. Once off the ground, loosen all the lug nuts until they come off. Pull the flat tire straight off. If you pull at an angle the rim may catch on the bolt threads and make it difficult to pull off.

7. Roll the old tire off to behind the vehicle, and grab your spare tire. Many times the spare will look smaller than the original. That is because it is just made to be a temporary tire to get you to the tire garage and get the flat tire repaired or replaced.

8. Take your spare tire and line up the bolt holes with the rim with the bolts or holes on the hub and try to put it straight on.

9. Holding the tire on with one hand, take one of your tire bolts and start to screw it into the top hole. Once that is tight enough to hold the rim on, hand tighten the rest of the bolts on.

10. Take your wrench and firmly snug them all up using a criss cross pattern instead of going clock-wise or counter-clockwise.

11. Slowly lower the jack so the tire is now on the ground. Give each bolt a good turn to make sure they are all tight.

12 Don't forget to put the jack and wrench back in their compartments, and throw the flat in your trunk. Since most spares are temporary it is wise to head straight to the tire center and have your tire fixed or replaced as soon as possible.

Follow these steps to keep your frustrations to a minimum with your unfortunate circumstance. If you ever feel you are in an unsafe area, call a tow truck to either change it for you or tow you to a garage that can help.

Friday, October 16, 2015

Fall Driving Safety Tips

Fall means a number of wonderful things, like warm, comfy sweaters, foliage, and baking pumpkin pies. For drivers, fall also brings unique dangers to the roads. Find out what makes fall driving dangerous and what you can do to keep yourself safe.


Why Driving In The Fall Can Be Dangerous

Weather conditions can be unpredictable in the fall. A bright, beautiful afternoon can turn rainy and cold in minutes. And with days getting shorter, you could find yourself commuting to or from work in darkness.

Back-to-school traffic
Fall means back to school for kids, which means more cars and buses on the roads. Drivers also need to watch out for increased pedestrian traffic in the morning and afternoon as children walk to and from school and their neighborhood bus stops.

Rain
The first rain in a few weeks can be particularly dangerous, as water pools on top of dust and oil that haven't had a chance to wash away and makes the pavement extremely slippery.

Leaves (and leaf peepers)
Fall foliage is certainly beautiful, but as leaves begin to fall, they litter the roads, making streets slick while obscuring traffic lines and other pavement markings. They also hide potholes and other road hazards. And when it rains, it can make those wet leaves on the roadway as dangerous as ice.

And where there are turning leaves, there are leaf peepers. These leaf-peeping drivers tend to crawl along the roads and make unpredictable stops to admire the changing foliage. If you're driving behind a car with out-of-state plates, give them a little extra space just in case they stop short for a photo.

Fog
Cold fall mornings often lead to fog, which can greatly limit your driving visibility and perception of distance. Fog tends to occur in low places or areas surrounded by hills, water, mountains, and trees. One common mistake drivers make during foggy conditions is putting on their high beams instead of staying with their low beams. This only makes visibility worse because your high beams will bounce off the fog and create glare.

When driving through fog, slow down and stay well behind the car in front of you so you'll have adequate time to stop if you need to.

Frost
During the fall, temperatures tend to drop dramatically during the night, which can lead to morning frost and icy spots on the road. This is especially common on bridges, overpasses, and shaded areas of the road.

Sun glare
Fall is also a bad time for sun glare on the roads. Sun glare can impact your sight for seconds after exposure, making it hard to see pedestrians, oncoming traffic, or the car in front of you. According to the National Highway Traffic Safety Administration, drivers describe being "blinded" after exposure, and this sometimes leads to accidents or near misses.

Sun glare can also cause problems when the sun sets behind drivers. In this case, sunlight can bounce off your rearview mirror or reflect off traffic lights up ahead, and this can blind you for a split second while your eyes adjust. It can also make it hard (or impossible) to see traffic lights, which can prevent you from knowing if you're supposed to stop or go.

Deer
The fall season brings an increase in deer activity because it's their time for mating and migrating. If you live in a deer-heavy area, watch for darting deer, especially when driving at night.

Fall Driving Tips
  • Being prepared for fall's inclement weather and hazardous driving challenges is half the battle.
  • Watch your speed: Drive a bit slower when faced with fall driving hazards, especially if you're driving around a school bus.
  • Keep your distance: Leave a little more space between you and the car in front on rainy or foggy days, during dawn or dusk, and in areas with wet leaves. This will give you more time to react.
  • Stick with low beams: Keep your headlights on low when driving in the fog (and rain). High beams will only cause glare.
  • Clear frost away from your windows: Frost can reduce visibility and response time on the road.
  • Approach traffic lights carefully: Sun glare can make it harder to see traffic lights change, so approach them with more than the normal care.
  • Avoid using products that increase gloss: Washing and waxing with these products can magnify the fall's sunny glare and make it hard to see.
  • Clean your windshield, inside and out: When your windshield's illuminated by sunlight, dust particles, streaks, and smudges become magnified, making it hard to see the road.
  • Watch for wildlife: especially in the early morning and evening hours.
  • Check your tire pressure: Since fall weather rapidly changes from warm to cold, your tires will often expand and contract. This can lead to a loss of pressure.

Source: www.esurance.com